Twist Lock Fixings for Slat Walls —Pack of 4

Hang things on your slat wall without drilling it. Each fixing slots into the felt gap between two slats, twists 90° to lock in behind them, and leaves a central hole ready for your screw — so nothing shows on the face of the panel and nothing is permanent.

Insert → Twist → Secure

1. Insert — push the fixing into the gap between two slats
2. Twist — rotate 90° so it locks in behind
3. Secure — screw your hook, bracket or fitting into the centre hole

No tools needed to fit them, and no marking out. Twist one back and it lifts straight out, leaving nothing behind.

What people mount with them

• Shelf brackets and floating shelves
• Coat hooks, towel rails and key racks
• Picture frames, canvases and mirrors
• Cable clips and cable tidies
• Lightweight planters and hanging pots
• Soundbar brackets and AV accessory rails

Check your gap first

This pack fits panels with a 13mm-20mm felt gap between the slats. Slat panels vary between brands, so measure yours before ordering — message us with a photo and a measurement if you're unsure and we'll tell you honestly whether these will fit.

Designed for panels where the slats are stapled to the felt backing. Insert each fixing by hand rather than forcing it; if one meets resistance, move along a little and try again, as you've most likely found a staple.

A note on weight

How much a fixing will safely hold depends on your installation rather than on the fixing alone. It varies with how your panel is built, how securely the panel itself is attached to the wall behind it, the screws you choose, and what you're mounting. Spread the load across several fixings, add weight gradually and check it holds before you trust it, and please don't rely on a single fixing for anything heavy or mounted overhead.

In the pack

4 × matte black twist lock fixings,. Screws not included — an M3 to M4 self-tapping screw suits most fittings.

Made and dispatched from the UK.